Bio-rad SmartSpec Plus Spectrophotometer User Manual download pdf (Page 13)

12. Time convention. You may choose to print time in 12-hour or 24-hour mode. Toggle

between the choices by pressing Select. and then press Enter.

Press Select for

13. Date convention. You can choose to print the date in either MM/DD/YY or DD-MM-

YY mode. Toggle between the choices by pressing Select and then press Enter.

Press Select for

14. Performance Validation. The Performance Validation function requires the purchase

of the SmartSpec Plus with Performance Validation Package (170-2520) or the separate

Performance Validation Package (170-2509). SmartSpec Plus will automatically perform

absorbance and wavelength tests and create a printable report.

Press Enter to access the Performance Validation program. Enter the four digit

Validation Cuvette number found on the Cuvette's certificate of analysis.

After entering absorbance information found on the Validation Cuvette's certificate of

analysis, the SmartSpec Plus will automatically perform wavelength and absorbance

accuracy tests. This process can take up to 5 minutes to complete. When finished, a

report may be printed.

15. Exit Setup. After going through the entire Setup menu, the display will return to the

Home screen. All changes will be saved. You can also exit Setup at any time by

pressing Cancel and all changes up to that point will be saved.

4.3 Serial Port Functions

The SmartSpec Plus has the ability to communicate with an external printer or

computer via the serial port located at the back of the instrument. The SmartSpec Plus

sends data to these peripherals as ASCII text. When connecting the SmartSpec Plus to an

external printer or computer, a "standard serial" cable should be used. The correct pin-out

for this cable is described in the table below. Check the printer or computer for the correct

serial port connector end (male or female).

DB9F Connector Signal and DB9M Connector

to SmartSpec Plus (male) Direction to serial device

2 TX - - > 3

3 < - - RX 2

5 Common 7

(other pins are open in SmartSpec Plus)

Select date display mode

MM/DD/YY

e.g. 11/25/98

Select date display mode

DD-MM-YY

e.g. 25-11-98

Select time display mode

24-hr

e.g. 13:12

Select time display mode

12-hr

e.g. 1:12

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Comments to this Manuals

No comments

Bio-rad SmartSpec Plus Spectrophotometer User Manual Page 13

Comments to this Manuals

Related products and manuals for Measuring instruments Bio-rad SmartSpec Plus Spectrophotometer